101 Basic Series - Module 14 - CEU Education
Your final score on this exam will be emailed to you for your records.
First name:   Last name:  
Company name:   E-Mail Address  
City   State  
Province (Optional)   Country (Optional)  
1
Which of the following is NOT an example of a busway fitting?
2
The most common length of busway is ____.
3
The Fusible Switch and Circuit Breaker Bus Plugs are very similar.  Both are used to connect a load to the busway while providing ____ protection for the load.
4
The following is a picture of a _________ connector.
5
You cannot get surge suppression in a bus plug.
6
A type of busway used to feed power to a distant point is called Feeder Busway.
7
One problem with busway is that sections cannot be connected in certain configurations, which limits where power can be supplied.
8
Select the two types of busway from the list below.
9
Sections of busway are connected using ____.
10
You can quote both indoor and outdoor busway based on the customer application needs.
11
___________ busway is comparable to an extension cord end in that it provides outlets to connect devices.
12
Ampere ratings for busway range from ______ to _____.
13
A hanger is provided for every _______feet of busway.
14
All busway is capable of handling up to 600V.
15
Busway sections that allow busway to turn corners, branch off, etc. allowing busway to run virtually anyway are ____.
16
A device used to support the weight of the busway, keeping it straight, is called a ____.
17
The utility company delivers power from the power plant to a building's service entrance.
18
In a busway, the conductors are insulated with ____, and covered by an aluminum enclosure to prevent accidental contact.
19
Busway is usually a little more expensive to install than cabling and conduit.
20
A device used to connect loads to the busway is called a _________.
 
   



Created and managed with SmartLite WebQuiz XP