101 Basic Series - Module 02 - Post Assessment
Your final score on this exam will be emailed to you for your records.
Ohm's law is represented using a triangular diagram to determine the proper formulas to calculate voltage, current (amps) and resistance.
Electromagnetism is an interaction between a magnetic field and a voltage source.
Insulators are materials that don't readily give up electrons, thereby restricting the flow of current.
Electrons can be freed by applying an external force, such as movement through a magnetic field, heat, friction, or a chemical reaction.
Single-phase is used where large blocks of power are required in commercial and industrial facilities.
What is the wattage of a 120 volt household light bulb that has a resistance of 192 ohms and uses .625 amps? (P = I
None of the above
The instantaneous value of a sine wave is the value at any particular time from zero to the peak value.
In a series circuit, when more than one resistance is in the circuit, the resistances are multiplied together to get the total resistance. (R
The current flow in a parallel circuit divides itself between the branches back to the source.
A magnetic field consists of lines of force, which are more commonly referred to as flux lines.
In the United States, Alternating Current (AC) is generated at ____________ hertz.
None of the above
Despite the fact that it has been positively determined that electron flow is the correct theory, conventional flow theory still dominates the industry.
If the diameter of a conductor is doubled, the resistance is doubled.
Electromagnetism is an interaction between electric current and a magnetic field.
The three methods that voltage forces current to flow are direct current, alternating current, and pulsating current.
Using the triangle that represents Ohm's law, the formula for calculating current is
E = I x R
R = E/I
I = E/R
Voltage is the rate at which energy is drawn from a source that produces a flow of electricity in a circuit.
The voltage value as measured across each resistor or load, in a series circuit, is called
The peak value of a sine wave occurs at the positive maximum and again at the negative maximum.
A(n)________is the basic unit of power, the amount of work accomplished when one volt causes one ampere to pass through a circuit.
Created and managed with SmartLite WebQuiz XP