101 Basic Series - Module 14 - Post Assessment
Your final score on this exam will be emailed to you for your records.
First name:   Last name:  
Company name:   E-Mail Address  
City   State  
Province (Optional)   Country (Optional)  
1
A device used to support the weight of the busway, keeping it straight, is called a ____.
2
Sections of busway are connected using ____.
3
A device used to connect loads to the busway is called a _________.
4
One problem with busway is that sections cannot be connected in certain configurations, which limits where power can be supplied.
5
A type of busway used to feed power to a distant point is called Feeder Busway.
6
Busway is usually a little more expensive to install than cabling and conduit.
7
You can quote both indoor and outdoor busway based on the customer application needs.
8
The following is a picture of a _________ connector.
9
Busway sections that allow busway to turn corners, branch off, etc. allowing busway to run virtually anyway are ____.
10
Which of the following is NOT an example of a busway fitting?
11
Select the two types of busway from the list below.
12
You cannot get surge suppression in a bus plug.
13
In a busway, the conductors are insulated with ____, and covered by an aluminum enclosure to prevent accidental contact.
14
___________ busway is comparable to an extension cord end in that it provides outlets to connect devices.
15
The Fusible Switch and Circuit Breaker Bus Plugs are very similar.  Both are used to connect a load to the busway while providing ____ protection for the load.
16
All busway is capable of handling up to 600V.
17
A hanger is provided for every _______feet of busway.
18
The most common length of busway is ____.
19
Ampere ratings for busway range from ______ to _____.
20
The utility company delivers power from the power plant to a building's service entrance.
 
   



Created and managed with SmartLite WebQuiz XP